cisco C9500-32QC端口拆分命令
在Cisco C9500-32QC交换机上,可以使用以下命令拆分端口:
- 进入特定接口配置模式:
configure terminal
interface <interface>
其中,<interface>
是要拆分的端口号。
- 使用以下命令将端口拆分为两个子接口:
split interface <subinterface1> <subinterface2>
其中,<subinterface1>
和<subinterface2>
是要创建的子接口号。例如,可以使用split interface GigabitEthernet1/0/1 1/0/1.1 1/0/1.2
将GigabitEthernet1/0/1端口拆分为GigabitEthernet1/0/1.1和GigabitEthernet1/0/1.2两个子接口。
-
配置每个子接口的相关参数,例如VLAN ID、IP地址等。
-
退出接口配置模式:
exit
- 保存配置:
write memory
请注意,以上命令仅适用于C9500-32QC交换机,对于其他型号的交换机可能有所不同。在进行配置操作之前,请确保已经了解相关文档和官方命令参考
原文地址: https://gggwd.com/t/topic/ijz8 著作权归作者所有。请勿转载和采集!